Optimization of Cr-doped ZnO Thin Films Deposited by Chemical Spray Pyrolysis for Enhanced Structural, Photoluminescence, and Morphological Performance


Authors : P. B. Sarwade; V. V. Gaikwad; B. A. Sarwade; Dr. G. H. Jadhav

Volume/Issue : Volume 10 - 2025, Issue 11 - November


Google Scholar : https://tinyurl.com/3nkk7szz

Scribd : https://tinyurl.com/2wte5a6m

DOI : https://doi.org/10.38124/ijisrt/25nov678

Note : A published paper may take 4-5 working days from the publication date to appear in PlumX Metrics, Semantic Scholar, and ResearchGate.

Note : Google Scholar may take 30 to 40 days to display the article.


Abstract : Cr-doped ZnO (CrZnO) thin films were deposited on glass substrates using chemical spray pyrolysis (CSP). The study systematically investigates the influence of Cr concentration (0–2 at%), substrate temperature (300–450 °C), and spray parameters on structural, morphological, and photoluminescence (PL) properties. X-ray diffraction (XRD) analysis reveals that all films crystallize in the wurtzite ZnO structure with preferential orientation; low-level Cr incorporation leads to a modest decrease in crystallite size and a small lattice distortion, while higher doping (≥3 at%) introduces secondary-phase features and increased defect density. Scanning electron microscopy (SEM) show grain refinement and reduced surface roughness at optimized doping and deposition conditions. Room-temperature PL spectra show a strong near-band-edge (NBE) UV emission and a reduced visible deep-level emission (DLE) for films optimized at 1–2 at% Cr, indicating lower nonradiative recombination and fewer oxygen-vacancy-related defects. The optimized CrZnO films (2 at% Cr, substrate temperature 375 °C, precursor concentration 0.1 M, spray rate 2 mL min−1) demonstrated the best combined structural order, strong NBE PL, and smooth morphology, making them promising for optoelectronic and sensing applications.

Keywords : Zinc Oxide, Chromium Doping, Chemical Spray Pyrolysis, Photoluminescence, Thin Films, Optimization, Morphology.

References :

  1. Özgür, Ü., Alivov, Y. I., Liu, C., Teke, A., Reshchikov, M. A., Doğan, S., ... & Morkoç, H. (2005). A comprehensive review of ZnO materials and devices. Journal of Applied Physics, 98(4), 041301.
  2. Janotti, A., & Van de Walle, C. G. (2009). Fundamentals of zinc oxide as a semiconductor. Reports on Progress in Physics, 72(12), 126501.
  3. Singh, A. K., & Mehra, R. M. (2012). ZnO thin films for optoelectronic device applications: A review. Materials Science in Semiconductor Processing, 15(1), 73–84.
  4. Morkoç, H., & Özgür, Ü. (2009). Zinc Oxide: Fundamentals, Materials and Device Technology. Wiley-VCH.
  5. Rao, K. N., Suresh, S., & Reddy, K. V. (2018). Structural, optical, and photoluminescence studies of Cr-doped ZnO thin films. Journal of Alloys and Compounds, 735, 1655–1662.
  6. Abbas, M., & Ahmed, N. (2017). Influence of Cr doping on structural, optical, and electrical properties of ZnO thin films grown by spray pyrolysis. Superlattices and Microstructures, 111, 370–378
  7. Yakuphanoglu, F. (2010). Cr-doped ZnO thin films: Structural and electrical characterization. Applied Surface Science, 256(12), 3481–3486.
  8. H. Saadi, Z. Benzarti, F.I.H. Rhouma, P. Sanguino, S. Guermazi, K. Khirouni, M.T. Vieira, Enhancing the electrical and dielectric properties of ZnO nanoparticles through Fe doping for electric storage applications, J. Mater. Sci. Mater. Electron. 32 (2021) 1536–1556. https://doi.org/10.1007/s10854-020-04923-1.
  9. X. Wang, S. Li, L. Xie, X. Li, D. Lin, Z. Zhu, Low-temperature and highly sensitivity H2S gas sensor based on ZnO/CuO composite derived from bimetal metal-organic frameworks, Ceram. Int. 46 (2020) 15858–15866. https://doi.org/10.1016/j.ceramint.2020.03.133.
  10. A. Maache, A. Chergui, D. Djouadi, B. Benhaoua, A. Chelouche, M. Boudissa, Effect of La doping on ZnO thin films physical properties: Correlation between strain and morphology, Optik (Stuttg). 180 (2019) 1018–1026. https://doi.org/10.1016/j.ijleo.2018.11.002.
  11. S. Mathuri, K. Ramamurthi, R. Ramesh Babu, Effect of Sb incorporation on the structural, optical, morphological and electrical properties of CdSe thin films deposited by electron beam evaporation technique, Thin Solid Films 660 (2018) 23–30. https://doi.org/10.1016/j.tsf.2018.05.041.
  12. M. Benelmekki, J. Vernieres, J.H. Kim, R.E. Diaz, P. Grammatikopoulos, M. Sowwan, On the formation of ternary metallic-dielectric multicore-shell nanoparticles by inert-gas condensation method, Mater. Chem. Phys. 151 (2015) 275–281. https://doi.org/10.1016/J.MATCHEMPHYS.2014.11.066.
  13. P. Shunmuga Sundaram, S. Stephen Rajkumar Inbanathan, G. Arivazhagan, Structural and optical properties of Mn doped ZnO nanoparticles prepared by co-precipitation method, Phys. B Condens. Matter 574 (2019) 411668. https://doi.org/10.1016/j.physb.2019.411668.
  14. F. Acosta-Humánez, C.J. Magon, L. Montes-Vides, O. Almanza, Structural, Optical and EPR Study of Zn1−xFexO Nanocrystals, J. Low Temp. Phys. 202 (2021) 29–47. https://doi.org/10.1007/s10909-020-02541-z.
  15. H. Ennaceri, A. Taleb, M. Boujnah, A. Khaldoun, J. Ebothé, A. Ennaoui, A. Benyoussef, Theoretical and experimental studies of Al-doped ZnO thin films: optical and structural properties, J. Comput. Electron. 20 (2021) 1948–1958. https://doi.org/10.1007/S10825-021-01744-1/METRICS.
  16. C. Prabakar, S. Muthukumaran, V. Raja, Influence of defects on the structural, optical, photoluminescence and magnetic properties of Cr/Mn dual doped ZnO nanostructures, Chem. Phys. Impact 2 (2021) 100019. https://doi.org/10.1016/j.chphi.2021.100019.
  17. M.J. Abdullah, A.A. Aziz, H. Ahmad, Applied Surface Science Low operating temperature of oxygen gas sensor based on undoped and Cr-doped ZnO films, Appl. Surf. Sci. 256 (2010) 3467–3470. https://doi.org/10.1016/j.apsusc.2009.12.055.
  18. Rani, S., et al. Structural and optical properties of Cr-doped ZnO nanoparticles synthesized by sol–gel method. Ceramics International, 40 (2014): 12337–12342.
  19. Chandak, V. S., et al., “Structural, optical and magnetic studies of Cr-doped ZnO …” (2025). ScienceDirec
  20. Fu, C., Chen, X., Li, L., Han, L.-F., Wu, X.-G., “Effects of the Cr doping on structure and optical properties of ZnO thin films,” Optoelectron. Lett. 6, 37–40 (2010). SpringerLink
  21. Fu, C.-F., Han, L.-F., Liu, C., et al., “Influence of annealing on microstructure and properties of Cr-doped ZnO thin films deposited on glass surfaces,” J. Mater. Sci.: Materials in Electronics (2017). ResearchGate
  22. Basak, D., et al. “Effect of Cr doping on structural and optical properties of ZnO thin films.” Materials Chemistry and Physics, 99 (2006): 74–78.
  23. Kumar, S., et al. Influence of transition metal (Cr, Mn) doping on structural, morphological and gas sensing      properties of ZnO thin films.” Applied Surface Science, 257 (2011): 9793–9799.
  24. Singhal, M., et al. Photoluminescence and optical properties of Cr-doped ZnO thin films prepared by spray   pyrolysis.” Journal of Luminescence, 132 (2012): 2372–2378.
  25. Patil, P. S., et al. Spray pyrolysis deposition of nanostructured Cr-doped ZnO thin films: Structural, optical and photoluminescence studies.” Materials Letters, 65 (2011): 1460–1463.

Cr-doped ZnO (CrZnO) thin films were deposited on glass substrates using chemical spray pyrolysis (CSP). The study systematically investigates the influence of Cr concentration (0–2 at%), substrate temperature (300–450 °C), and spray parameters on structural, morphological, and photoluminescence (PL) properties. X-ray diffraction (XRD) analysis reveals that all films crystallize in the wurtzite ZnO structure with preferential orientation; low-level Cr incorporation leads to a modest decrease in crystallite size and a small lattice distortion, while higher doping (≥3 at%) introduces secondary-phase features and increased defect density. Scanning electron microscopy (SEM) show grain refinement and reduced surface roughness at optimized doping and deposition conditions. Room-temperature PL spectra show a strong near-band-edge (NBE) UV emission and a reduced visible deep-level emission (DLE) for films optimized at 1–2 at% Cr, indicating lower nonradiative recombination and fewer oxygen-vacancy-related defects. The optimized CrZnO films (2 at% Cr, substrate temperature 375 °C, precursor concentration 0.1 M, spray rate 2 mL min−1) demonstrated the best combined structural order, strong NBE PL, and smooth morphology, making them promising for optoelectronic and sensing applications.

Keywords : Zinc Oxide, Chromium Doping, Chemical Spray Pyrolysis, Photoluminescence, Thin Films, Optimization, Morphology.

CALL FOR PAPERS


Paper Submission Last Date
30 - November - 2025

Video Explanation for Published paper

Never miss an update from Papermashup

Get notified about the latest tutorials and downloads.

Subscribe by Email

Get alerts directly into your inbox after each post and stay updated.
Subscribe
OR

Subscribe by RSS

Add our RSS to your feedreader to get regular updates from us.
Subscribe